What's up with her pm+1, +2 and +3?

Status
Not open for further replies.

Mandy S

Member Since 2020
I've never seen Sissy's numbers do this before. Her PMPS was lower than her +1, +2 and +3 and all three of those numbers aren't budging? I gave her the regular dose she's been getting...1.25 of Lantus.
Why are they higher than her PMPS?
 
Because she's a cat and driving the hoomin crazy is just what they do?....LOL

But seriously, it looks like she might just be doing a baby bounce. She did drop to 107 today and although that's nowhere near "too low", it's lower than she's been before.

I wondered if it was a bounce. I'm not sure how to recognize that yet..I've read about it here, but not confident in my spreadsheet reading skills yet. lol I was so excited she got into those lower numbers today and told her so...she's maybe letting me know to chill out.
 
@Panic , I always shoot then she stays in my lap and I pet her some more and I didn't feel anything wet on her fur. So I really don't think so. I just thought it was odd for her. I looked over her spreadsheet and this is a new one...never has gone up more than the pre shot number before.
 
On thing though....IF she continues with flat yellow throughout this cycle, be ready for tomorrow.

Sometimes those flat yellow cycles can precede a very active cycle....not always, but enough that we watch the next cycle carefully after someone's had a flat yellow
 
She came down a little finally...not much though.

So looking at this...is it likely she'll just stay up through the night? Or should I test her later. I wonder if she'll have a big drop?

Also, I was thinking about her shot. I tent up her skin like we're supposed to, but she's been not liking that much lately and it's actually harder to do the last few days...like there's not as much give with her skin. Is it possible I gave it in the wrong layer? I really don't think I did, and I don't know if that matters? The possible fur shot question above had me thinking back to her shot. I know it wasn't wet...but was thinking of the difference in the last few cycles of her skin.
 
Last edited:
Well...it's going on 3am...I might as well test one more time before I go to bed. By the time I let the dogs out and brush my teeth it will be time for a +5.

I think I'm going to start moving her test time back an hour so that on most nights, I will be able to go to sleep earlier. I picked 10 as the shot time because usually someone is here at that time morning or night. But I didn't realize at the beginning that you don't just test before a shot! ha!
 
Well she never did really drop last night. She was still 295 at AMPS this morning. It's just strange because it was a total different cycle than she had before. I really am wondering if I didn't mess up her shot somehow...I know it wasn't a fur shot, maybe I didn't get the right amount in the needle...although I check and recheck to the point of madness so I don't think that's it either. I guess it's just her weirdness. I'll check her again at +2 and see how she is today.
 
Hi Mandy,

Some doses get better absorbed than others. Some Lantus cycles are more 'active', some less.

Sissy stayed nice and steady through the night. As Chris said above:

Sometimes those flat yellow cycles can precede a very active cycle....not always, but enough that we watch the next cycle carefully after someone's had a flat yellow
Lets see how Sissy gets on today. :)


Mogs
.
 
Hi Mandy,

Some doses get better absorbed than others. Some Lantus cycles are more 'active', some less.

Sissy stayed nice and steady through the night. As Chris said above:


Lets see how Sissy gets on today. :)


Mogs
.

I'm glad she stayed steady all night. I'll watch her today. I'm hoping she'll curl up with me here in a bit and take a nap. I'm dragging bad today.

I have a spreadsheet question...if I need to start a new thread I will, but if you know how to fix it, great. The borders on my spreadsheet are missing on a lot of posts. I've tried editing and putting borders back but it's not working. It's making me crazy.
Anyone know how to fix it?
 
This is how I see it on my app on my phone or from my computer with Windows 10.
When I open everyone else's the boxes all have lines around each entry.
 

Attachments

  • Screenshot_20200823-142949_Sheets.jpg
    Screenshot_20200823-142949_Sheets.jpg
    44.2 KB · Views: 104
Morning, ladies. :)

I'm now getting the same 'missing cell borders' problem as Mandy has on Sissy's spreadsheet when it's displayed on both my Windows 10 PC and my Android tablet.

I wonder whether this might be a Google software issue? When I accessed Sheets just now they've changed it to automatically use a black background, not a white one (you can change it in the settings) so they've definitely been mucking around with stuff behind the scenes.


Mogs
.
 
Morning, ladies. :)

I'm now getting the same 'missing cell borders' problem as Mandy has on Sissy's spreadsheet when it's displayed on both my Windows 10 PC and my Android tablet.

I wonder whether this might be a Google software issue? When I accessed Sheets just now they've changed it to automatically use a black background, not a white one (you can change it in the settings) so they've definitely been mucking around with stuff behind the scenes.

There's definitely a problem with Google Sheets. I've reported it in the FDMB Tech Support Forum.

Mogs
.

It drives me nuts to have to change it to the white background every time. I do use it from my laptop the most but when I do have to use the app it's annoying. I'm glad I'm not just seeing things. lol Thanks for checking and reporting it.
 
Status
Not open for further replies.
Back
Top