Merlin
Very Active Member
4/25
Micro Meter
AMPS 345; .8U
Good morning!
You asked how the feeder went last night? Well, it worked great. I put in enough for two feedings at 1am and 4am. It appears that it turned correctly and on time ... however, Merlin didn't eat one little bite. So I guess I will have to run it today so he can get used to it. I thought about that last night but I didn't get it all set up until late. So I think it is going to work out great. Stay tuned for an update tomorrow!
Thanks Jen for looking over my scale. There are a couple of numbers that are pending. That is, I like to list the numbers/unit that didn't perform well and "pend" it but not change it yet. Then try the same number/unit again (according to current sliding scale) and if it doesn't work again, then update the scale. This is what I have so far.
Current Sliding Scale
420+ - 1.2U
390+ - 1
330+ - .8
250+ - .6
200+ - .4
175+ - .2
Pending Sliding Scale
520 - +1.4u
420+ - 1.2U
380+ - 1
280+ - .8
230+ - .6
200+ - .4
175+ - .2
The numbers/unit that are in red are the ones that are pending. I haven't had the chance to test the two lower numbers yet because we have not been there. Anyway, I need to test the above numbers (in red) one more time before I change the sliding scale.
Micro Meter
AMPS 345; .8U
Good morning!
You asked how the feeder went last night? Well, it worked great. I put in enough for two feedings at 1am and 4am. It appears that it turned correctly and on time ... however, Merlin didn't eat one little bite. So I guess I will have to run it today so he can get used to it. I thought about that last night but I didn't get it all set up until late. So I think it is going to work out great. Stay tuned for an update tomorrow!
Thanks Jen for looking over my scale. There are a couple of numbers that are pending. That is, I like to list the numbers/unit that didn't perform well and "pend" it but not change it yet. Then try the same number/unit again (according to current sliding scale) and if it doesn't work again, then update the scale. This is what I have so far.
Current Sliding Scale
420+ - 1.2U
390+ - 1
330+ - .8
250+ - .6
200+ - .4
175+ - .2
Pending Sliding Scale
520 - +1.4u
420+ - 1.2U
380+ - 1
280+ - .8
230+ - .6
200+ - .4
175+ - .2
The numbers/unit that are in red are the ones that are pending. I haven't had the chance to test the two lower numbers yet because we have not been there. Anyway, I need to test the above numbers (in red) one more time before I change the sliding scale.